Skutt EnviroVent 2 Bedienungsanleitung

www.skutt.com6441 SE JOHNSON CREEK BLVD. PORTLAND, OR 97206 (503) 774--6000 [email protected] 7/07/15Mdf`shudOqdrrtq dNegative PressureOperatin

101010CusTom InsTallaTIonsvEnting oval kilnS & kilnS ovEr 12 cubic fEEtOn kilns over 12 cubic feet, and up to 24 cubic feet, you will need a Dual

1111CusTom InsTallaTIonsuSing cEntral ducting If you have more than one EnviroVent 2, you may connect them to a central duct. If a central duct is

121212operaTIonopErationLoading the Kiln The bottom kiln shelf needs to be supported at least one inch off the kiln oor to allow sufcient air circu

1313troublEShootingproblem: VenT noT operaTIngPossibleCause: No Power to the vent.Solutions:Check to see the vent is plugged in.Check to make sure th

141414accESSory itEmSDual Intake Kit The Dual Intake Kit is used when you are venting 2 kilns that are each at or under 12 Cubic Feet or when you are

1515SpecicationsMotor: 115 volt 1.4 amps 50/60 HzHeat exiting blower: 160 °F maximumBlower: 140 cfm Maximum kiln capacity for use with EnviroVent

222Table of ConTenTsConTenTsIntroduction ... 3Setup ...

33InTroduCTIonHow It WorksA designated number of holes are drilled in the lid and oor of the kiln either in the factory or on location. A spring loa

444seTupStandard EnvirovEnt 2 inStallationThis section of the manual covers standard installations of The EnviroVent 2 on a single top loading, multi

55seTupStEp 1 - prEparation• Unplug the kiln• At the time of purchase it is possible to order the kiln factory drilled. If your kiln has already be

666seTupKiln Chamber DepthDrill This Many Holes In SlabDrill This Many Holes In LidDrill Size Kiln Cubic Feet714 and GlazeTech 1 2 3/16” 1.1 thru 1.4E

77seTupStEp 5 - inStalling thE plEnum cup and Spring Stand• Using gloves to protect your hands, stretch the ex tubing to the proper length for your

888seTupStEp 7 - tESting thE EnvirovEnt2 for propEr opEration• Check to make sure the plenum cup has not shifted during installation. It should be pe

99CusTom InsTallaTIonsdual intakE kitA Dual Intake Kit is required when you are venting 2 kilns with one Envirovent 2 or a single kiln that is greater